User`s guide

Configuration>System>Time/Date
350
AlterPath OnSite Administrator’s and User’s Guide
ii. Enter an acronym in the “Standard Time Acronym” field.
iii. Enter the number of hours and minutes off Greenwich Mean Time
in the “GMT off” field.
iv. If desired, check the “Enable daylight saving time” checkbox.
v. Click OK.
3. Go to one of the procedures listed below to configure the time.
• “To Configure Time and Date [Expert]” on page 350.
• “To Configure Time and Date [Expert]” on page 350
Enabling NTP
If “Enable” is selected from the Network Time Protocol menu, a screen like
the one shown in the following figure appears.
Figure 6-114:NTP Enable Screen
T To Configure Time and Date [Expert]
1. Perform the procedure under “To Configure the Time Zone [Expert]” on
page 349.
2. To configure an NTP server, do the following steps.
a. Select “Enable” from the Network Time Protocol menu.
The “NTP Server” field appears.
b. Type the IP address of the NTP server in the “NTP Server” field.