User`s guide

Configuration>Network>SNMP
326
AlterPath OnSite Administrator’s and User’s Guide
The related tasks are listed in the following table.
T To Configure SNMP [Expert]
1. Go to Configuration>Networks>SNMP in Expert mode.
The SNMP screen appears.
2. To enable any version of SNMP, do the following:
• To add an SNMPv1/SNMP2 entry, press the “Add” button under the
“
SNMPv1/SNMPv2 Configuration” table.
• To add an SNMPv3 entry, press the “Add” button at the bottom of the
“SNMPv3” table.
The “New/Modify SNMP Daemon Configuration” dialog box appears.
3. To edit any SNMP configuration, do the following steps.
a. To edit an SNMPv1/SNMP2 entry, select the entry from the
“
SNMPv1/SNMPv2 Configuration” list and click the “Edit”
button.
b. To edit an SNMPv3 entry, select an entry from the “SNMPv3” list and
click the “Edit” button.
The “New/Modify SNMP Daemon Configuration” dialog box appears.
4. For SNMP v1 or v2 configuration, enter or change the following
information:
a. Enter the community name in the “Community” field.
b. Enter the source IP address or range of IP addresses in the “Source”
field.
5. For SNMP v3 configuration, enter or change the following information:
Table 6-26: Tasks for Configuring SNMP
Task Where Documented
Enable SNMP. “To Configure SNMP [Expert]” on page 326
Configure one or more serial
ports to send SNMP traps.
“To Configure a Trigger for SNMP Trap Notification for
Serial Ports Expert]” on page 272