User`s guide

Configuration>Network>PCMCIA Management
318
AlterPath OnSite Administrators and Users Guide
Figure 6-80:CDMA PCMCIA Card Configuration Dialog Box—Call Back
T To Configure a CDMA PCMCIA Card [Expert]
1. Install the CDMA card and select “CDMA” from the pull-down menu on
the PCMCIA Management screen.
See “To Begin Configuring a PCMCIA Card [Expert]” on page 306, if
needed.
2. Enter an IP address in the “Local IP” field, if desired.
By default, the IP address of the OnSite is used. Only change the IP
address if you have a specific reason to do so.
3. In the “Remote IP” field, specify the IP address to assign to the other end
of the PPP connection, if desired.
By default, the IP address 10.0.0.1 is assigned. Only change the IP
address if you have a specific reason to do so.
4. Select a speed from the “Speed” pull-down menu.
5. To enable call back, do the following:
a. Check the “Call Back” check box.
b. Enter a number for the OnSite to use to call back the CDMA phone in
the “Phone Number” field.