User`s guide

Configuration>Serial/AUX>Notifications
268
AlterPath OnSite Administrator’s and User’s Guide
5. Accept or make any changes desired to the modem initialization
commands in the “Modem Initialization:” text area.
6. For PPP, do the following steps.
a. Enter an IP address in the “Local IP” field.
b. In the “Remote IP” field, specify the IP address to assign to the other
end of the PPP connection.
c. Check or leave unchecked the checkbox next to “Authentication
Required.”
d. Accept or change the number in the “MTU/MRU” field.
e. Accept or make any changes desired to the PPP options in the “PPP
Options” text area.
7. Click “apply changes.”
Configuration>Serial/AUX>Notifications
Selecting Configuration>Serial/AUX>Notifications in Expert mode brings up
a screen like the one shown in the following figure.
Figure 6-42:Web Manager Configuration>Serial>Notifications Screen
An administrative user can
use this screen to enable notifications about
system crashes or other events of interest that occur on the device that is
connected to the serial port. Data buffering must be enabled. The
administrative user an configure notifications to be sent either by email, pager,
or SNMP trap.