User`s guide
Configuration>Serial/AUX>Aux/Modem Port
266
AlterPath OnSite Administrator’s and User’s Guide
T To Configure an AUX Port for IPDU Power
Management [Expert]
This procedure assumes an AlterPath PM intelligent power distribution unit
(IPDU) is connected to one of the AUX ports.
1. Go to Configuration >Serial/AUX>Aux/Modem Port in Expert mode.
2. Select either the AuxPort1 or AuxPort2 tab, as appropriate.
3. Make sure the checkbox next to “Enable Port” is checked.
4. Make sure the “Power Management” option is selected from the “Profile”
menu.
5. Click “apply changes.”
T To Configure an AUX Port for PPP [Expert]
This procedure assumes an external modem is connected to the selected AUX
port.
1. Go to Configuration >Serial/AUX>Aux/Modem Port in Expert mode.
2. Select either the AuxPort1 or AuxPort2 tab, as appropriate.
3. Make sure the checkbox next to “Enable Port” is checked.
4. From the “Profile:” pull-down menu, select PPP or Login.
Additional fields appear on the screen.
&Wn
Store current configuration.
n = 0 or 1
Stores current modem settings in non-volatile memory and causes them to
be loaded at power-on or following the ATZ command instead of the factory
defaults. See also the &F command.
&W1 Clears user default settings from non-volatile memory and causes the
factory defaults to be loaded at power-on or following the ATZ command.
Table 6-20: Commonly-Used Supported AT Commands (Sheet 4 of 4)
Command Definition