User`s guide
Web Manager for OnSite Administrators 263
Configuration>Serial/AUX>Aux/Modem Port
AT Commands for Modem Initialization
In most cases, the default modem initialization commands are acceptable. For
when changes are necessary, this section provides a brief introduction to the
AT (ATtention code) commands that are used to control the modem’s
operation. The command format is ATXn, where X is the command and n is
the numeric value for the command. If the value is 0 (zero), it can be omitted
from the command. For example, AT&W is the same as AT&W0. The following
table defines the most-commonly-used commands: ATA, ATD, ATH, ATM,
ATV, ATZ, AT&F, and AT&W.
Authentication Required
Check the checkbox to require authentication.
MTU/MRU
The maximum transmission unit / maximum receive units
for the PPP.
PPP Options
The default options are:
proxyarp modem asyncmap 000A0000
noipx noccp login novj require-pap
refuse-chap
ms-dns 0.0.0.0
plugin /usr/lib/libpsr.so
Table 6-20: Commonly-Used Supported AT Commands (Sheet 1 of 4)
Command Definition
AT
Attention Code.
Precedes all command lines except A/, A:, and escape sequences.
A
Answer call before final ring.
A/
Repeat last command.
Table 6-19: Fields for Configuring PPP on AuxPort or ModemPort Screens (Sheet 3 of 3)
Field Name Definition