User`s guide

Configuration>Serial/AUX>Aux/Modem Port
262
AlterPath OnSite Administrator’s and User’s Guide
Modem Initialization
The modem initialization string is used to configure the
modem when it is turned on or when the communications
software calls another modem. The default is:
TIMEOUT 10
"" \d\l\dATZ
OK\r\n-ATZ-OK\r\n ""
TIMEOUT 10
"" ATM0
OK\r\n ""
TIMEOUT 3600
RING ""
STATUS Incoming %p:I.HANDSHAKE
"" ATA
TIMEOUT 60
CONNECT@ ""
STATUS Connected %p:I.HANDSHAKE
If you need to change how the modem is initialized, see
Table 6-20, “Commonly-Used Supported AT Commands,”
on page 263.
Local IP Address
The local IP address used by PPP to set up the session
between the local and the remote modem. By default, the IP
address of the OnSite is used. Use the default unless you
have a specific reason to use another IP address.
Remote IP Address
The remote IP address used by PPP to set up the session
between the local and the remote modem. By default, the IP
address 10.0.0.1 is used. Use the default unless you have a
specific reason to use another IP address.
Table 6-19: Fields for Configuring PPP on AuxPort or ModemPort Screens (Sheet 2 of 3)
Field Name Definition