User`s guide

Configuration>Serial/AUX>Physical Ports>Other
254
AlterPath OnSite Administrator’s and User’s Guide
When one of the dumb terminal connection options in the General screen is
selected (see Table 6-13, “Protocols for Dumb Terminals Connected to Serial
Ports,” on page 233), additional fields appear on this screen and some fields
disappear, as shown in the following figure.
Figure 6-37:Web Manager Configuration>Serial/AUX>Physical
Ports>General Screen—Other Screen When Terminal Protocol
is Selected
For dumb terminals dedicated to remote servers you need to specify a host IP
address in the “Host to Connect” field. For any type of dumb terminal, you
need to enter the type of terminal in the “Terminal Type” field.
T To Configure TCP Port Number, STTY
Options, Break
Interval, and the Login
Banner for a Serial Port Connected to
a
Console [Expert]
1. Go to Configuration>Serial/AUX>Physical Ports in Expert mode, and
select a port or ports to modify.
If needed, see “To Select One or More Serial Ports [Expert]” on page 193.
Six tabs appear.