User`s guide

Configuration>Serial/AUX>Physical Ports>Power Management
250
AlterPath OnSite Administrators and Users Guide
port 3 is plugged into outlets 1, 4, 5, 6, 7, and 8 on an IPDU connected to
AUX port 1.
Figure 6-35:Web Manager Configuration>Serial/AUX>Physical
Ports>Power Management—Add Outlets Example
If more than one IPDU is daisy-chained to a port configured for power
management, the outlet numbers are specified sequentially. For example, if
two IPDUs are daisy-chained, and the first IPDU has eight outlets, then you
would enter the number 14 to indicate the sixth outlet on the second IPDU.
T To Configure a Serial Port for IPDU or IPMI
Power
Management [Expert]
This procedure assumes the prerequisites described in “Configuration>Serial/
AUX>Physical Ports>Power Management” on page 247 are completed.
Perform this procedure to enable power management of a device that is
connected to a serial port when that device is plugged into one or more outlets
on an AlterPath PM IPDU that is connected to an AUX port on the OnSite and
properly configured.
1. Go to Configuration>Serial/AUX>Physical Ports in Expert mode, and
select a port or ports to modify.
If needed, see “To Select One or More Serial Ports [Expert]” on page 193.
Six tabs appear.
2. Click the “Power Management” tab.