User`s guide

Web Manager for OnSite Administrators 235
Configuration>Serial/AUX>Physical Ports> General
Serial/AUX>Physical Ports>General>Modem and
Power Management Connection Protocols
The following table shows the connection protocols for modems or AlterPath
PM IPDUs connected to the serial ports.
Complete the TS profile (terminal type, host
IP address and TCP port number) as
required by the connection protocol
“To Configure Dumb Terminal Server
Connection Options [Expert]” on page 255
For a dumb terminal configured with the
Local Terminal protocol, configure an
optional menu to display when the terminal
is turned on and connected to a session on
the OnSite
“To Create a Menu for a Dumb Terminal
[Expert]” on page 209
Table 6-15: Protocols for Serial Ports Connected to Modems or IPDUs
Protocol Name Result
PPP-No Auth Starts a PPP session without interactive authentication required.
Assumes the specified OnSite serial port is connected to an external
modem.
PPP Starts a PPP session with authentication required. Assumes the
specified OnSite serial port is connected to an external modem.
SLIP Starts a SLIP session. Assumes the specified OnSite serial port is
connected to an external modem.
CSLIP Starts a CSLIP session. Assumes the specified OnSite serial port is
connected to an external modem.
Power Management Configures the serial port for power management. Assumes an
AlterPath PM IPDU is connected to the serial port.
Table 6-14: Tasks for Configuring a Dumb Terminal (Continued)
Task Where Documented