User`s guide
Configuration>KVM>General>IP Users
222
AlterPath OnSite Administrator’s and User’s Guide
3. To change the screen saver timeout, enter a different number of minutes in
the “Screen Saver Timeout” field.
4. To change the keyboard type, select a different keyboard from the
“Keyboard type” pull-down menu.
5. To change the cycle time, enter a different number of seconds in the
“Cycle Time” field.
6. To change any of the command key portions of KVM hot key
combinations, enter a different letter in the “Quit,” “Power Management,”
“Mouse/Keyboard Reset,” “Video Control,” “Switch Next,” “Switch
Previous,” or “Port Info” fields.
7. Click “apply changes.”
T To Configure IP Users (KVM Over IP)
Sessions [Expert]
Perform this procedure if you want to redefine the parameters that apply to
KVM port sessions when a remote user is connected through the Web
Manager (in a KVM over IP session).
1. Go to Configuration>KVM>General>IP Users in Expert mode.
2. To change the idle timeout, enter a different number of minutes in the
“Idle Timeout” field.
3. To change the TCP port number used by the AlterPath Viewer, enter
another number in the “TCP Viewer Ports” field.
4. Check the radio button next to the desired level or type of encryption.
5. If the “Escape Sequences” area appears on the screen, to optionally
change any of the command key portions of KVM hot key combinations,
enter a different letter in the “Quit,” “Power Management,” “Mouse/
Keyboard Reset,” “Video Control,” “Switch Next,” “Switch Previous,” or
“Port Info” fields.
6. Click “apply changes.”