User`s guide
Web Manager for OnSite Administrators 221
Configuration>KVM>General>IP Users
T To Configure Local User Sessions [Expert]
Perform this procedure if you want to redefine the parameters that apply to
KVM port sessions that are started by a user who is directly logged into the
OnSite through a Local User station.
1. Go to Configuration>KVM>General>Local User in Expert mode.
2. To change the idle timeout, enter a different number of minutes in the
“Idle Timeout” field.
TCP Viewer Ports Change the number of the TCP port used for the AlterPath
Viewer. [IP User only.] The default is 5900+. You may need to
change the default, for example, if your firewall is blocking port
5900. (For more details, see “Port Numbers and Aliases” on
page 47.) Port numbers 1-1024 are reserved. Indicate a range of
ports by entering a plus sign (+) after the first port number (as in
2500+) or by entering a dash between two port numbers (as in
2500-2501). Indicate a set of nonadjacent port numbers by
separating port numbers with commas (as in 2500, 2508).
IP Security Specify the level and type of encryption. If the radio buttons for
Level 1 or Level 2 are selected, RC4 encryption is used unless
the 3DES checkbox is also selected.
Escape Sequence
Note:This area does
not appear when this
screen displays on the
newest OnSite
hardware, because the
“Show Connections”
menu replaces the hot
keys. (See “What You
See When Connected to
a KVM Port” on page
82.)
Optionally redefine the command key portion of keyboard
shortcuts for each type of user. For more information about
redefining keyboard shortcuts, see “Configuring Keyboard
Shortcuts (Hot Keys)” on page 63 and “To Redefine KVM Port
Connection Hot Keys [Expert]” on page 215 if needed.
Table 6-9: Session Parameters for Local User and IP Users (Continued)
Field Name Definition