User`s guide

Web Manager for OnSite Administrators 195
Access>IPDU Power Mgmt.>Users Manager
Access>IPDU Power Mgmt.>Users Manager
Selecting the “Users Manager” tab under Access>IPDU Power Mgmt. in
Expert mode brings up a screen like the one shown in the following figure.
Figure 6-4: Web Manager IPDU Power Mgmt.> Users Manager Screen
An administrative user can use this screen to assign users to outlets. Figure 6-
4 shows the screen that displays when a single AlterPath PM IPDU is
connected to AUX port 1, which has been configured for power management.
The list is empty because no users have been configured for power
management.
If more than one port is configured for power management, multiple user lists
appear, one for each IPDU power management port.
Configure names, alarms, logging, and
over-current protection for IPDUs.
“Access>IPDU Power
Mgmt.>Configuration” on page 197
To Specify Names, Alarms, Syslogging,
and Over-current Protection for IPDUs
[Expert]
Upgrade AlterPath PM IPDU information “Access>IPDU Power Mgmt.>Software
Upgrade” on page 199
To Upgrade Software on an AlterPath PM
[Expert]
Table 6-3: Power Managment Configuration Tasks Performed Only by Administrative Users