User`s guide

Web Manager for OnSite Administrators 187
Common Tasks
Configure local or remote data buffering
(to save console input to a log file) and
specify alarms for trigger events on
serial port(s).
• ““To Configure Data Buffering for Serial
Ports [Expert]” on page 243
• “To Choose a Method for Sending
Notifications for Serial Port Data Buffering
Events [Expert]” on page 270
Configure logging of system messages to
a syslog server.
• “To Specify Names, Alarms, Syslogging, and
Over-current Protection for IPDUs [Expert]”
on page 198
• “To Configure Syslogging and Message
Filtering [Expert]” on page 304
Configure power management for one or
both of the AUX ports (if the port is
connected to an optional AlterPath PM
or other supported IPDU device).
• “To Configure an AUX Port for IPDU Power
Management [Expert]” on page 266
Also see the procedures under “Access>IPDU
Power Mgmt.” on page 193 including:
• “To View Status, Lock, Unlock, Rename, or
Cycle Power Outlets” on page 150
• “To View and Reset IPDU Information
[Expert]” on page 153
Configure servers for IPMI power
management.
“Access>IPMI Power Mgmt.” on page 204
Choose among authentication methods
and specify authentication servers for the
following:
• Logins to the OnSite • “To Configure an OnSite Login
Authentication Method [Expert]” on page
277
• Logins to devices through KVM ports. • “To Configure an Authentication Method for
Direct Access to KVM Ports [Expert]” on
page 217
Table 6-1: Common OnSite Administration Tasks (Sheet 2 of 3)
Task Where Documented