User`s guide
Introduction 173
Step 3: Serial Port Profile [Wizard]
Note: You cannot configure KVM ports in Wizard mode. To configure KVM
ports, see “Configuration>KVM” on page 212.
The following table lists the tasks for configuring serial ports with links to
where they are documented.
Table 5-2: Tasks for Configuring Serial Ports
To Configure Serial Ports [Wizard] Page 174
To Select One or More Serial Ports [Expert] Page 228
To Enable or Disable Serial Ports [Expert] Page 229
To Configure a Serial Port Connection Protocol for a Console Connection
[Expert]
Page 236
To Configure a Serial Port Connection Protocol for a Dumb Terminal [Expert] Page 237
To Configure an Alias for a Serial Port [Expert] Page 238
To Configure Serial Port Settings to Match the Connected Device [Expert] Page 238
To Configure Serial Port Access for Users [Expert] Page 240
To Configure a Serial Port Authentication Method [Expert] Page 241
To Configure Data Buffering for Serial Ports [Expert] Page 243
To Configure Multiple Serial Port Sessions and Port Sharing [Expert] Page 246
To Configure a Serial Port for IPDU or IPMI Power Management [Expert] Page 250
To Configure a User for IPDU Power Management for a Serial Port [Expert] Page 252
To Configure TCP Port Number, STTY Options, Break Interval, and the Login
Banner for a Serial Port Connected to a Console [Expert]
Page 254
To Configure Dumb Terminal Server Connection Options [Expert] Page 255
To Choose a Method for Sending Notifications for Serial Port Data Buffering
Events [Expert]
Page 270
To Configure a Trigger for Email Notification for Serial Ports [Expert] Page 271
To Configure a Trigger for Pager Notification for Serial Ports [Expert] Page 272