User`s guide

Introduction 169
Step 2: Network Settings [Wizard]
Figure 5-7: Web Manager Wizard Step 2: Network Settings screen—
Without DHCP
If the “DHCP” checkbox is checked, the screen appears as shown in the
following figure.
Figure 5-8: Web Manager Wizard Step 2: Network Settings Screen—
DHCP
During initial setup of the OnSite, the administrator configures the basic
network settings that are needed to enable logins through the Web Manager.
(See “Performing Basic Network Configuration” on page 67, if desired, for
more about the initial network configuration.) You can skip this step if the
current settings are correct. Check with your network administrator if you are
not sure.