System information
Appendix B: Advanced Boot and Backup Configuration Information 411
Changing the Boot Image
2. Enter the cycli command.
The cli> prompt appears.
3. Enter the get bootconf command to check the current configuration
to find out which boot command and boot image are being used.
In the screen example, hw_boot is defined as the bootcmd and
image2 is defined as the image.
4. To boot from a TFTP boot server over the network, do the following
steps.
a. Set the bootcmd to net_boot.
b. Specify the TFTP boot server’s IP address.
c. Specify the name of the boot file on the TFTP server.
The currentimage environment variable is changed to boot from the
specified image.
# cycli
cli>
cli> get bootconf
...
bootconf bootcmd: hw_boot
...
bootconf image: 2
cli> set bootconf bootcmd net_boot
cli> set bootconf serverip IPaddress
cli> set bootconf bootfile allImage.1129-qa0