System information

Using the cycli Utility 325
cycli Commands
If the system assigns default values, default values are shown next to the
automatically added parameter name, as in the following example, which was
entered on the OnBoard before any configuration has been done.
Example:
Note: If you make a change but do not commit it (see “commit” on page
322), the configuration files are not updated. The get command shows the
changes that are currently stored in the RAM memory, not the actual value
stored in the affected configuration file.
list
List available parameters. With no parameters listed, the whole parameter tree
is displayed. If parameters are specified, the corresponding subtree is
displayed.
list [parameter(s)]
Example:
cli> get network interface eth0
network interface eth0 active: yes
network interface eth0 method: dhcp
network interface eth0 address: 192.168.160.10
network interface eth0 netmask: 255.255.255.0
network interface eth0 broadcast: 192.168.160.255
network interface eth0 gateway: none
network interface eth0 mtu: 1500
cli>
cli> list network hosts
network hosts 127.0.0.1 name
network hosts 127.0.0.1 alias
network hosts 192.168.160.10 name
network hosts 192.168.160.10 alias