System information

Using the cycli Utility 311
cycli Commands
Example:
cycli Commands
The cycli utility supports the commands that are listed in the following
screen example, which are described in the following sections with examples.
add
The add command adds the last parameter and sets it to the default value (if
any). Any non-default values must be added using the set command.
add
parameter(s) value
cli> s<Tab> <Tab>
set shell show
cli> se<TAB>
cli> set n<TAB><TAB>
network notifications ntp
cli> set ne<TAB>
cli> set network <TAB><TAB>
hostname hosts interface resolv smtp st_routes
cli> set network i<TAB>
cli> set network interface eth0 <TAB><TAB>
active address broadcast gateway method mtu netmask
cli> set network interface eth0 ac<TAB>
cli> set network interface eth0 active <TAB>
enable or disable eth0 with yes or no
cli> set network interface eth0 active <ESC><TAB>
cli> set network interface eth0 active yes <TAB><TAB>
active address broadcast gateway method mtu netmask
cli> set network interface eth0 active yes b<TAB>
cli> set network interface eth0 active yes broadcast
10.0.0.255<Enter>
OK
cli>
cli> <Tab><Tab>
add commit exit list rename set show
cd delete get quit revert shell version