System information

Configuring SNMP
246 AlterPath OnBoard Administrator’s Guide
The fields on the screen shown in Figure 7-40 vary according to which SNMP
protocol type is selected. Figure 7-40 shows the fields when v1 or v2 is
selected.
Figure 7-41 shows the fields when v3 is selected from the “SNMP version”
menu.
Figure 7-41:Config → Device SNMP Settings Dialog With V3 Selected
T To Begin Configuring SNMP for a Device
1. Log into the Web Manager as an administrative user.
2. Go to Config → SNMP.
3. Click the “SNMP configure” button for the desired device under the
“Servers SNMP configuration” heading.
The “Device devicename SNMP settings” dialog appears.
4. Proceed to the following procedures.
• “To Configure a Device’s SNMP Settings” on page 246
• “To Configure a Device’s SNMP Access Settings” on page 247
T To Configure a Device’s SNMP Settings
Do this procedure to configure how the OnBoard authenticates itself to the
selected device when proxying SNMP functionality for the device.
1. Select a device to configure on the Config → SNMP page, as described
under“To Begin Configuring SNMP for a Device” on page 246.
2. Click “Edit” under the “Service Processor SNMP setting” heading.