System information

Configuring Sensor Alarms
236 AlterPath OnBoard Administrator’s Guide
Figure 7-30:Config → Sensor Alarms SNMP Trap Fields for V1 and V2c
The fields that appear when SNMP v1 and v2 are selected are the same, but
when SNMP v3 is selected other fields appear, as shown in Figure 7-31.
Figure 7-31:Config → Sensor Alarms SNMP Trap Fields for V3
See “SNMP on the OnBoard” on page 26 for values to define SNMP traps.
T To Configure an SNMP Trap Sensor Alarm
Action
1. Perform Step 1 through Step 9 in the procedure “To Begin Configuring a
Sensor Alarm” on page 234, selecting “SNMP trap” from the “Action”
menu in Step 8.
2. Select a protocol from the “Protocol” menu.
3. Enter the OID in the “OID” field.
4. Select a trap type from the “Generic trap type” field.