System information

Web Manager "Config" Menu Options 233
Configuring Sensor Alarms
Configuring Sensor Alarms
When an administrative user goes to Config Sensor alarms, the screen
shown in the following figure appears. The administrative user can use this
screen to configure the OnBoard to check sensor readings from service
processors and to configure alarms to be sent if the sensor readings are not
within certain specified values. See “OnBoard Sensor Alarms” on page 44 for
an introduction and values needed to configure sensor alarms.
Figure 7-27:Default Config Sensor Alarms Screen
Figure 7-27 shows the screen as it appears when no alarms are configured.
Figure 7-28 shows the screen that appears when the “Add new alarm” button
is clicked on the screen that is shown in Figure 7-27. As shown, by default, the
“Syslog message” option is selected from the “Action” menu.
Figure 7-28:Default Config Sensor Alarms Screen