System information

Web Manager Wizard 125
Configuring Network Interfaces—Wizard
Configuring Routes
Configuring the network interfaces sets up a default route for the OnBoard.
When the DHCP checkbox is checked on any of the network interface
screens, the DHCP server assigns the OnBoard a default route. If the DHCP
checkbox is not checked, the gateway IP specified by the administrative user
in the “Gateway IP” field is used to create a default route for the interface. If a
host or network route is required, the administrative user should go to the
Network Static routes screen.
Configuring Failover
If failover is enabled on the “Network Interfaces” screen, clicking the “Next”
button brings up a screen for configuring the failover device. The following
figure shows the fields that appear on the screen for configuring the failover
device if the DHCP option is not checked. If the DHCP option is not checked,
no further configuration is needed. Clicking the “Next” button brings up the
subnet configuration screen.
Figure 4-12:“Configure Failover Device” Screen
With failover enabled, the secondary Ethernet interface becomes bonded to
the primary Ethernet interface, and the secondary Ethernet interface becomes
active only if the primary Ethernet port is not available. As a result, the values
Broadcast IP The reserved broadcast IP address.
Table 4-3: Ethernet Port Settings
Settings Notes