Installation guide

55
B
Safety Information
Follow the precautions in this appendix when installing Cyclades products.
Failure to observe the listed precautions may result in personal injury or
damage to equipment. Failing to observe compliance requirements makes the
equipment no longer compliant. See Appendix A, “Specifications” on page 47
for specific standards and compliance information for the AlterPath OnBoard.
General Safety Precautions
Observe the following general safety precautions when setting up and using
Cyclades equipment.
• Follow all cautions and instructions marked on the equipment.
• Follow all cautions and instructions in the installation documentation or
on any cautionary cards shipped with the product.
• Do not push objects through the openings in the equipment. Dangerous
voltages may be present. Objects with conductive properties can cause
fire, electric shock, or damage to the equipment.
• Do not make mechanical or electrical modifications to the equipment.
• Do not block or cover openings on the equipment.
• Chose a location that avoids excessive heat, direct sunlight, dust, or
chemical exposure, all of which can cause the product to fail. For
example, do not place a Cyclades product near a radiator or heat register.
which can cause overheating.
• Connect products that have dual power supplies to two separate power
sources, for example, one commercial circuit and one uninterruptible
power supply (UPS). The power sources must be independent of each
other and must be controlled by separate circuit breakers.
• For products that have AC power supplies, ensure that the voltage and
frequency of the power source match the voltage and frequency on the
label on the equipment.