Service manual

Chapter 6 Configuration 54
Cyclades-TS Installation & Service Manual
FIGURE 6.13 REMOTE ACCESS SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONTINUED)
Parameter Description Value for This
Example
s1.tty The device name for the port is set to the value given in this
parameter. If a device name is not provided for a port, it will not
function.
ttyS1
s32.tty See the s1.tty entry in this table. ttyS32
FIGURE 6.13 REMOTE ACCESS SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONTINUED)
Execute the command signal_ras hup to activate the changes. At this point, the configuration should be
tested. A step-by-step check list follows.
1. Since Radius authentication was chosen, create a new user on the Radius authentication server called test
and provide him with the password test.
2. From the console, ping 200.200.200.2 to make sure the Radius authentication server is reachable.
3. Make sure that the physical connection between the Cyclades-TS and the modems is correct. The modem
cable provided with the product should be used. Please see the hardware specifications appendix for pin-
out diagrams.
4. The Cyclades-TS has been set for communication at 57600 bps, 8N1. The modems should be programmed
to operate at the same speed on the DTE interface.
5. Try to dial in to the Cyclades-TS from a remote computer using the username and password configured in
item one. The computer dialing in must be configured to receive its IP address from the remote access
server (the Cyclades-TS in this case) and to use PAP authentication.
Now continue on to step four.