Service manual

Chapter 6 Configuration 47
Cyclades-TS Installation & Service Manual
Parameter Description Value for
This Example
all.issue This text determines the format of
the login banner that is issued when
a connection is made to the
Cyclades-TS. \n represents a new
line and \r represents a carriage
return.
\r\n\ TSLINUX - Portslave Internet Services\n\
\r\n\ Welcome to terminal server %h port S%p \n\
\r\n\ Customer Support: 510-770-9727
www.cyclades.com/\n\
\r\n
all.prompt This text defines the format of the login prompt. Expansion characters,
listed in Appendix C, can be used here.
%h login:
all.term This parameter defines the terminal type assumed when performing
rlogin or telnet to other hosts.
vt100
all.flow This sets the flow control to hardware, software, or none. hard
all.socket_port This parameter defines the port(s) to be used by the protocols telnet and
socket_client. If not configured, a default value of 23 is used.
Note: socket_server is not valid in this case (TS profile).
23
all.userauto Username used when connected to a Unix server from the user’s serial
terminal.
s1.tty The device name for the port is set to the value given in this parameter.
If a device name is not provided for a port, it will not function.
ttyS1
s16.tty See the s1.tty entry in this table. ttyS16
FIGURE 6.10 TERMINAL SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONTINUED)
Execute the command signal_ras hup to activate the changes. At this point, the configuration should be
tested. A step-by-step check list follows.
1. Since authentication was set to none, the Cyclades-TS will not authenticate the user. However, the Linux
Server receiving the connection will. Create a new user on the server called test and provide him with the
password test.