Service manual

Chapter 6 Configuration 46

Cyclades-TS Installation & Service Manual

Parameter Description Value for

This Example

all.authhost1 This address indicates the location of the Radius/TacacsPlus

authentication server and is only necessary if this option is chosen in the

previous parameter. A second Radius/TacacsPlus authentication server

can be configured with the parameter all.authhost2.

200.200.200.2

all.accthost1 This address indicates the location of the Radius/TacacsPlus accounting

server, which can be used to track how long users are connected after

being authorized by the authentication server. Its use is optional. If this

parameter is not used, accounting will not be performed. If the same

server is used for authentication and accounting, both parameters must

be filled with the same address. A second Radius/TacacsPlus

accounting server can be configured with the parameter all.accthost2.

200.200.200.2

all.radtimeout This is the timeout (in seconds) for a Radius/TacacsPlus authentication

query to be answered. The first server (authhost1) is tried "radretries"

times, and then the second (authhost2), if configured, is contacted

"radretries" times. If the second also fails to respond, Radius/TacacsPlus

authentication fails.

all.radretries Defines the number of times each Radius/TacacsPlus server is tried

before another is contacted. The default, if not configured, is 5.

all.secret This is the shared secret necessary for communication between the

Cyclades-TS and the Radius/TacacsPlus servers.

cyclades

all.protocol For the terminal server profile, the possible protocols are login (which

requests username and password), rlogin (which receives the username

from the TS and requests a password), telnet, socket_client, ssh and

ssh2.

rlogin

all.host The IP address of the host to which the terminals will connect. 200.200.200.3

FIGURE 6.10 TERMINAL SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONTINUED)