Service manual

Chapter 6 Configuration 38

Cyclades-TS Installation & Service Manual

Parameter Description Value for This

Example

all.dont_show_DB

When zero, a menu with data buffering options is shown when a

nonempty data buffering file is found. When 1, the data buffering menu

is not shown. When 2, the data buffering menu is not shown but the

data buffering file is shown if not empty. When 3, the data buffering

menu is shown, but without the

erase

and

show and erase

options.

all.alarm When non zero, all data received from the port are captured and sent

to syslog-ng with LOCAL [0+DB_facility] facility and INFO level. The

file /etc/syslog-ng/syslog-ng.conf should be set accordingly, for the

syslog-ng to take some action (please see Appendix G for syslog-ng

configuration file).

all.users Restricts access to ports by user name (only the users listed can

access the port or, using the character "!', all but the users listed can

access the port .) In this example, the users joe, mark and members of

user_group cannot access the port. A single comma and spaces/tabs

may be used between names. A comma may not appear between the

! and the first user name. The users may be local, Radius or

TacacsPlus. User groups (defined with the parameter conf.group) can

be used in combination with user names in the parameter list. Notice

that these are common users, not administrators.

! joe, mark,

user_group

all.sniff_mode This parameter determines what other users connected to the very

same port (see parameter admin_users below) can see of the session

of the first connected user (main session):

shows data written to the

port,

out

shows data received from the port, and

i/o

shows both

streams. The second and later sessions are called sniff sessions and

this feature may be activated only when the protocol parameter is set

to socket_ssh or socket_server.

out

FIGURE 6.7 CONSOLE SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONT.)