Service manual

Chapter 6 Configuration 35
Cyclades-TS Installation & Service Manual
Parameter Description Value for This
Example
all.radtimeout This is the timeout (in seconds) for a Radius/TacacsPlus
authentication query to be answered. The first server (authhost1) is
tried "radretries" times, and then the second (authhost2), if configured,
is contacted "radretries" times. If the second also fails to respond,
Radius/TacacsPlus authentication fails.
3
all.radretries Defines the number of times each Radius/TacacsPlus server is tried
before another is contacted. The default, if not configured, is 5.
5
all.secret This is the shared secret necessary for communication between the
Cyclades-TS and the Radius/TacacsPlus servers.
cyclades
all.ipno This is the default IP address of the Cyclades-TS's serial ports. The
"+" indicates that the first port should be addressed as 192.168.1.101
and the following ports should have consecutive values. Any host can
access a port using its IP address as long as a path to the address
exists in the host's routing table.
192.168.1.101+
all.issue This text determines the format of
the login banner that is issued when
a connection is made to the
Cyclades-TS. \n represents a new
line and \r represents a carriage
return. Expansion characters, listed
in Appendix C, can be used here.
\r\n\ TSLINUX - Portslave Internet Services\n\
\r\n\ Welcome to terminal server %h port S%p \n\
\r\n\ Customer Support: 510-770-9727
www.cyclades.com/\n\
\r\n
all.prompt This text defines the format of the login prompt. Expansion
characters, listed in Appendix C, can be used here.
%h login:
all.flow This sets the flow control to hardware, software, or none. hard
FIGURE 6.7 CONSOLE SERVER PSLAVE.CONF PORT-SPECIFIC PARAMETERS (CONT.)