Service manual

Chapter 6 Configuration 30
Cyclades-TS Installation & Service Manual
The fourth file defines static routes and is called /etc/network/st_routes. In the console server example in
Figure 6.5, the PR1000 is the gateway router and thus its IP address is configured in this file to be the default
gateway. Other static routes are also configured in this file.
route add default gw 200.200.200.5
FIGURE 6.4 CONTENTS OF THE /ETC/NETWORK/ST_ROUTES FILE
NOTE: We strongly recommend to use 9600 bps console speed. In case you need to use other speed please
check the troubleshooting session.
STEP THREE
This is where the configuration for the three profiles - Console Server, Terminal Server and Remote Access
Server diverge. Follow step three for the appropriate profile.
STEP THREE - CONSOLE SERVER
A console server application is shown in Figure 6.5.