Service manual

149Appendix F Configuration Wizard
Cyclades-TS Installation & Service Manual
Console Access Server (CAS) profile:
Parameter Value Comments
speed 9600 Port speed - 9600bps
datasize 8 8 bits
stopbits 1 1 stop bit
parity none no parity
flow hard hardware flow control
dcd 0 not sensitive to DCD signal
sysutmp 1 write the users in utmp log file
syswtmp 0 Do not write the users in wtmp log file.
authtype radius Authentication can be through Radius, TACACS+ or Local.
authhost1 200.200.200.2 change it to the authentication server of your environment
accthost1 200.200.200.2 change it to the accounting server of your environment
radtimeout 3 3 minutes timeou
secret cyclades change it to the secret of the RADIUS/ TACACS+ server
radretries 5 5 retries before giving up authenticating
radnullpass 0 Don't allow users with null passwords.
protocol socket_server Telnet protocol. SSH (socket_ssh) and raw (raw_data) are also
supported.
ipno 192.168.1.101+ This value can be kept unless you access through IP address is
required.
socket_port 7001+ Change it to the TCP port to be used by the first serial port;
keep the
Incremented
option on.
issue \r\nWelcome to... This will be the banner when a login is required.
prompt %h login Login prompt. %h is the hostname.
term vt100 Other terminal types are available (ansi, linux).
tx_interval 100 Send buffer received to the application each 100ms.
poll_interval 0 Don’t send modem state commands.