Service manual

147Appendix F Configuration Wizard
Cyclades-TS Installation & Service Manual
If ‘y’ is entered, Figure F.9 is displayed. This figure explains what saving to flash means. Type ‘y’ if you want to
save to flash. Type ‘n’ if you don’t want to save to flash. You can now continue TS configuration using the web
browser by typing in the IP address of the TS. If you choose to not save to flash, all the new configuration will be
lost if you were to reboot the TS. However, all configuration will be kept if you saved to flash.
*******************************************************************
************* C O N F I G U R A T I O N W I Z A R D *************
*******************************************************************
You can now use the browser to finish your system configu-
rations, but before that, please read below.
Flash refers to a type of memory that can be erased and
reprogrammed in units of memory known as blocks rather than
one byte at a time; thus, making updating to memory easier. If you
choose to save to flash, your configurations thus
far will still be in the memory of the system even after you
reboot it. If you don't save to flash and if you were to
reboot the system, all your new configurations will be lost
and you will have to reconfigure the system. Do you want to save
your configurations to flash (Y/N) [N]:
FIGURE F.9
NOTE: Using telnet to configure the Cyclades-TS, if you reconfigure the IP address of the Ethernet interface you
are supposed to have your telnet connection lost. In that case, close the telnet client and reopen it using this time
the new IP address configurated for that TS box.