Service manual

139Appendix F Configuration Wizard
Cyclades-TS Installation & Service Manual
*******************************************************************
************* C O N F I G U R A T I O N W I Z A R D *************
*******************************************************************
Ok, let's get started! I need a few basic information on the system
so that it can know where it is located within the network and it
can know about its neighbor or its local environment.
Set to defaults? (y/n) [N] :
FIGURE F.1
The default answer or value to any question is in the brackets. For figure F.1, either just hit ENTER to execute
whatever is in between the brackets or type ‘n’ to NOT reset the current configurations to the Cyclades defaults
or type ‘y’ to reset to Cyclades default configurations.
The configuration begins in the next screens. There are instructions on how to use the wizard on each screen.
There is also an explanation of each parameter before asking for it. To use the rest of the ‘wiz’ application, follow
the instructions:
The default or the current value for the parameter is displayed inside the brackets. Just hit ENTER if you are
satisfied with the value in the brackets. If not, enter the appropriate parameter and press ENTER.
If at any time, you want to exit the wizard or you want to skip the rest of the configuration, press ESC. This will
immediately display a summary of the current configuration for your verification before exiting the application.