Service manual

Appendix F Configuration Wizard 138
Cyclades-TS Installation & Service Manual
APPENDIX F CONFIGURATION WIZARD
Using Wizard through CLI
The user has a choice to configure the Cyclades-TS using the standard vi editor. For those not familiar with the
editor, there’s a way to pre-configure the unit (just basic configuration such as IP address of the Cyclades-TS)
using the CLI. After that, they can continue configuring the unit through the WEB.
Once using the WEB, there’s a wizard button to set basic parameters for a given profile (CAS, TS or RAS) to
speed up the configuration process. This is used by customers who want basic features for a given profile.
Customers who want to explore the features for that profile (data buffering, session sniffing, etc) would use the
WEB thoroughly.
The configuration wizard application is a quicker and easier way to configure the Cyclades-TS. The use of this
application is recommended if you are not familiar with the vi editor or if you just want to do a quick configuration
of the TS.
The command ‘wiz’ gets you started with some basic configuration. After executing this, you can then use the
web configuration manager to continue configurations for the TS. The files that will be eventually modified if you
decide to save to flash at the end of this application are:
1. /etc/hostname
2. /etc/hosts
3. /etc/resolv.conf
4. /etc/network/st_routes
5. /etc/portslave/pslave.conf
Type ‘wiz’ in your TS terminal.