Service manual

Cyclades-TS
10
Chapter 2 - Safety Instructions
Installation & Service Manual
WORKING INSIDE THE CYCLADES-TS
NOTICE: Do not attempt to service the Cyclades-TS yourself, except following instructions from Cyclades
Technical Support personnel. If this is the case, first take the following precautions:
· Turn the Cyclades-TS off.
· Ground yourself by touching an unpainted metal surface on the back of the equipment before touching
anything inside it.
REPLACING THE BATTERY
A coin-cell battery maintains date and time information. The TS100 does not have the battery, so the date and
time must be kept up to date by ntpclient. If you have to repeatedly reset time and date information after turning
on your Cyclades-TS, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the 3 Volt CR2032 battery
only with the same or equivalent type recommended by the battery manufacturer. Discard used
batteries according to the battery manufacturer’s instructions.