Installation manual

95Appendix E The Web Configuration Manager
Cyclades-TS Installation Manual
Troubleshooting the Web Configuration Manager
1. What to do when the initial web page does not appear.
Try pinging, telnetting or tracerouting to the Cyclades-TS to make sure it is reachable. If not, the problem is
probably in the network or network configuration. Are the interfaces up? Are the IP addresses correct? Are
filters configured which block the packets?
If the Cyclades-TS is reachable, see if the /bin/webs process is running by executing the command ps. If it is
not, type /bin/webs & to start it. If the /bin/webs process is not being initialized during boot, change the file /
etc/inittab.
2. How to restore the default configuration of the Web Configuration Manager
This would be required only when the root password was lost or the configuration file /etc/websum.conf was
damaged.
From a console or telnet session, edit the file /etc/config_files. Find the reference to /etc/websum.conf and
delete it. Save the modified /etc/config_files file. Execute the command saveconf. Reboot the system.
Enter into the Web Configuration Manager with the default username and password (root/tslinux). Edit the file /
etc/config_files and insert the reference to /etc/websum.conf.