Installation manual

89Appendix E The Web Configuration Manager
Cyclades-TS Installation Manual
APPENDIX E THE WEB CONFIGURATION MANAGER
An HTML server to facilitate administration and configuration of the Cyclades-TS was implemented in software
v.1.3.0. To use this feature:
1.connect the Cyclades-TS to a terminal using the console cable,
2.log in to the Cyclades-TS from the terminal with root privileges,
3.change the IP address/mask/gateway using the command
config_eth0 ip 200.200.200.1 netmask 255.255.255.0 gw 200.200.200.5
replacing the IP numbers in the line above with IP numbers appropriate to your system.
4.Open a browser (Netscape, Internet Explorer, etc.) and type the IP address of the TS’s Ethernet interface
(200.200.200.1 above). A page similar to that shown in Fig. E.1 will appear.
Type root in the username field and tslinux in the password field to use the Web Configuration Manager.
Change the root password as soon as possible: the user database for the Web Configuration Manager is
different than the system user database, so the root password can be different.