Installation manual

Cyclades-TS

Appendix C - Sample pslave.conf files-The complete pslave.conf file

Installation Manual

# Speed. All ports are set to 9600 baud rate, 8 bits, No parity, 1 stop bit.

# These values can be changed port by port later in the file.

all.speed 9600

all.datasize 8

all.stopbits 1

all.parity none

# Syslog server message level. An integer between 0 and 7. Zero: does not send

# syslog messages to the syslog server.

all.syslog_level 4

# Syslog Console message level. An integer between 0 and 7. Zero: does not

send

# syslog messages to the console.

all.console_level 4

# Authentication type - either "local", "radius", "none", "remote"

# "local/radius", "radius/local", or "RadiusDownLocal".

# If the authentication type is configured as "local/radius" the portslave

# first tries to authenticate locally. If it fails, portslave will try to

# authenticate using the radius server.

# If the authentication type is configured as "RadiusDownLocal" the portslave

# first tries to authenticate using the radius server. If the Radius server

# sends back a rejection, authentication will fail. Local authentication

# will be tried only if the Radius server is down (timeout).

all.authtype radius

# Authentication host and accounting host. Two of each can be configured

# per port. The first is tried 'radretries' times before the

# second is tried. If 'radretries' is not configured, 5 is used by default.

# The parameter 'radtimeout' sets the timeout per query in seconds.

all.authhost1 192.168.160.3