Installation manual

Cyclades-TS

Appendix C - Sample pslave.conf files-The complete pslave.conf file

Installation Manual

# The Cyclades-TS can request all of its ethernet parameters to a DHCP server.

# The administrator can activate the dhcp client with more options changing

# the file /etc/network/dhcpcd_cmd.

#conf.dhcp_client 1

conf.eth_ip 192.168.160.10

conf.eth_mask 255.255.255.0

conf.eth_mtu1500

# Secondary IP address of ethernet

#conf.eth_ip_alias 192.168.161.10

#conf.eth_mask_alias 255.255.255.0

# Remote Network File System where data buffering will be written instead

# of the default directory '/var/run'. The directory tree to which the

# file will be written must be NFS-mounted.

# If data buffering is turned on for port 1, for example, the data will be

# stored in /tmp/ts_data_buffer/ttyS1.data on the machine with IP address

# 192.168.160.11. The remote host must have NFS installed and the

administrator

# must create, export and allow reading/writing to this directory.

# The size of this file is not limited by the value of the parameter

# s1.data_buffering, though the value cannot be zero since a zero value turns

# off data buffering.

#conf.nfs_data_buffering 192.168.160.11:/tmp/ts_data_buffer

# Lock directory - The lock directory is /var/lock for the Cyclades-TS.

# It should not be changed unless the user decides to customize the

# operating system.

conf.lockdir/var/lock

# Location of the rlogin binary that accepts the "-i" flag.