Installation manual

Chapter 4 Configuration 34
Cyclades-TS Installation Manual
Execute the command signal_ras hup to activate the changes. At this point, the configuration should be
tested. A step-by-step check list follows.
1. Since Radius authentication was chosen, create a new user on the Radius authentication server called test
and provide him with the password test.
2. From the console, ping 200.200.200.2 to make sure the Radius authentication server is reachable.
3. Make sure that the physical connection between the Cyclades-TS and the modems is correct. The modem
cable provided with the product should be used. Please see the hardware specifications appendix for pin-
out diagrams.
4. The Cyclades-TS has been set for communication at 57600 bps, 8N1. The modems should be programmed
to operate at the same speed on the DTE interface. Also make sure that the computer is configured to route
console data to the serial console port.
5. Try to dial in to the Cyclades-TS from a remote computer using the username and password configured in
item one. The computer dialing in must be configured to receive its IP address from the remote access
server (the Cyclades-TS in this case) and to use PAP authentication.
Now continue on to step four.
STEP FOUR - FOR ALL PROFILES
The next step is to update the system with the modified data in the files above. Make sure the file named /etc/
config_files contains the names of all files that should be saved to flash.
Next, the command saveconf, which reads the /etc/config_files file, should then be run. saveconf copies all the
files listed in the file /etc/config_files from the ramdisk to /proc/flash/script. The previous contents of the file /
proc/flash/script will be lost.