Installation manual

Chapter 4 Configuration 28
Cyclades-TS Installation Manual
Execute the command signal_ras hup to activate the changes. At this point, the configuration should be
tested. A step-by-step check list follows.
1. Since authentication was set to none, the Cyclades-TS will not authenticate the user. However, the Linux
Server receiving the connection will. Create a new user on the server called test and provide him with the
password test.
2. From the console, ping 200.200.200.3 to make sure the server is reachable.
3. Make sure that the physical connection between the Cyclades-TS and the terminals is correct. A cross cable
(not the modem cable provided with the product) should be used. Please see the hardware specifications
appendix for pin-out diagrams.
4. The Cyclades-TS has been set for communication at 9600 bps, 8N1. The terminals must also be configured
with the same parameters.
5. From a terminal connected to the Cyclades-TS, try to log in to the server using the username and password
configured in item one.
Now continue on to step four later in this chapter.
STEP THREE - REMOTE ACCESS SERVER
The remote access server profile allows a modem user to access the LAN. Radius authentication is used in this
example and ppp is chosen as the protocol.