Installation manual

Chapter 4 Configuration 23

Cyclades-TS Installation Manual

5. From a server on the LAN (not from the console), try to telnet to the server connected to the first port of the

Cyclades-TS using the following command:

telnet 200.200.200.1 7001

For both telnet and ssh sessions, the servers can be reached by either:

1. Ethernet IP of the Cyclades-TS and assigned socket port

2. Individual IP assigned to each port.

If everything is configured correctly, a telnet session should open on the server connected to port 1. If not, check

the configuration, follow the steps above again, and check the troubleshooting appendix. Now continue on to

step four later in this chapter.

STEP THREE - TERMINAL SERVER

The terminal server profile allows a terminal user to access a server on the LAN. The terminal can be either a

dumb terminal or a terminal emulation program on a PC. No authentication is used in this example and rlogin is

chosen as the protocol.