Installation manual

Chapter 4 Configuration 15
Cyclades-TS Installation Manual
route add default gw 200.200.200.5
FIGURE 4.4 CONTENTS OF THE /ETC/NETWORK/ST_ROUTES FILE
Now, use the bootconf utility to configure the boot parameters. The console speed parameter should be changed
if the terminal used as a console requires a different speed. The option to skip the flash test speeds up the boot
process. The last option determines the operational mode of the Ethernet connection.
Type bootconf on the command line. The script will first ask if you want to return all parameters to their default
values. If you respond No, it will ask you to enter parameter values one by one:
MAC address assigned to Ethernet [00:60:2e:00:0e:23]
IP address assigned to Ethernet interface [209.81.55.79]
Watchdog timer ((A)ctive or (I)nactive) [A]
TSLinux boot from ((F)lash or (N)etwork) [N]
Boot type ((B)ootp,(T)ftp or Bot(H)) [T]
Boot File Name [zvmppcts.eas]
Server’s IP address [209.81.55.126]
Console speed [9600]
(P)erform or (S)kip Flash test [S]
(S)kip, (Q)uick or (F)ull RAM test [S]
Fast Ethernet ((A)uto Neg, (1)00 BtH, 100 Bt(F), 10 B(t)F, 10 Bt(H)) [A]
after modifying these parameters, the script will ask:
Do you confirm these changes in flash ( (Y)es, (N)o (Q)uit ) [N] :
Y = changes are saved to flash
N = the parameters are presented again
Q = the script quits without saving any changes made
STEP THREE
This is where the configuration for the three profiles - Console Server, Terminal Server and Remote Access
Server diverge. Follow step three for the appropriate profile.