User's Manual

2 4
New Call Lam p
The Message W aiting Indicator / New Call Lam p will flash when there are new or
unviewed Caller ID entries in call log if the lam p is switched on.
Press [MENU].
Using [▼ ] / [▲ ] to access “NEW CALL LAMP”.
Press [O.K.] to enter into the selection.
Using [▼ ] / [▲ ] to switch the New Call Lam p ON or OFF.
Press [SAVE] to confirm .
Tim e and Date Setting
Press [MENU].
Using [▼ ] / [▲ ] to select “SET DATE/TIME”.
Press [O.K.] to enter into the selection.
Enter tim e with the num eric keys.
Press [EDIT] softkey to swap between AM and PM.
Using [▼ ] / [▲ ] to switch to date setting.
Enter the date with num eric keys.
Press [SAVE] to confirm setting.
Intercom Set Up
Choose the num ber of rings before the handset answers to an intercom call. W hen
“AUTO AFT 1 RING” or “AUTO AFT 3 RING” is selected, the unit will autom atically
answer an intercom call with speakerphone m ode.
Press [MENU].
Using [▼ ] / [▲ ] to access “INTERCOM SETUP”.
Press [O.K.] to enter into the selection.
Using [▼ ] / [▲ ] to select the desired option.
Press [SAVE] to confirm setting.
NEW CALL LAMP:v
ON
USE -CHANGE

EXIT
S AVE
TIME: v
10:05 (AM)
[EDIT]->AM/PM

EDIT O.K. EXIT
S AVE
DATE(MM/DD): v
03/25

O.K. EXIT
S AVE
DATE(MM/DD): v
03/25

O.K. EXIT
S AVE
SEE ANS MODE
AUTO AFT 1RING
AUTO AFT 3RING

EXIT
S AVE
IN IT I AL S E T T IN G S