User's Manual

42
If you are entering an unregistered handset num ber,
“INVALID NUMBER” is display and you need to repeat
the above step again.
The handset you called rings and “TRANSFER FROM
BS” on the display. Press [Talk] or [Spk.] on the
called handset, the call will be connected
autom atically.
If the handset you called does not answer in 20 seconds,
the unanswered call will ring back to you again.
Press [Talk] or [Spk.] to pick up the call again, or the
line will be release autom atically after 20 seconds if
you do not answer.
CALL CONFERENCING
Your new cordless system supports conference calls with one handset and base unit.
W hen engaging an external line, press [Talk] or [Spk.]
on another handset or press [Speakerphone] on the
base unit to enter a conference call.
“CONFERENCE” appears on the display of the base
unit. Press [OFF] on one handset or [Speakerphone]
on the base unit will only end that party from the call.
To end the call, m ake sure all parties have
disconnected from the line and returned to standby
m ode.
Note:
This phone system can allow you to conference or intercom by using the handset and
base sim ultaneously. If the handset is operated too close to the base unit, you m ay
experience feedback noise. Should this occur, m ove the handset away from the
base unit and the feedback will stop.
INVALID NUMBER
EXIT
TRANSFER FROM BS
EXIT
PHONE ON
SERVICE DIR. DIAL V.M
PHONE ON
SERVICE DIR. DIAL V.M
CONFERENCE
.
M U LT I- H AN D SET O P E R AT IO N