User guide

56
87654321
O
N
EXPANSION REMOTE USER TRANSMITTER
PWB: 016-0102 REV. A
JP1JP5JP9
JP13JP17JP21
JP26
JP2JP6JP10
JP14JP18JP22
JP3JP7JP11
JP15JP19JP23
JP4JP8JP12
JP25
JP16JP20JP24
8
7
6
5
4321
O
N
DIP SWITCH
DEFAULT
Before installing your transmitter and receiver boards in your XP4000 system,
you will need to configure them for your system requirements. There are two
steps to configuring your expansion boards:
1) Configuring the 8-position DIP switch on the transmitter boards with a
unit address.
2) Configuring the jumpers on the transmitter and receiver boards for your
specific expansion cable length.
Please note that the same settings apply to both the standard and Category 5
expansion transmitter and receiver cards.
Configuring the Transmitter DIP Switch
All units that contain transmitters must be given a unique unit address that you
determine. Unit addresses are numeric, and may be any value between 1 and
254. Please note that unit addresses of “0” and “255” are reserved. Every
transmitter in a given unit must be configured for the same unit address for
proper operation.
To set the DIP switch on your transmitters, follow the steps below:
1) Locate all of the transmitters that will be installed in a single XP4000
Series unit.
2) Orient your first transmitter board as shown below, and locate the colored
DIP switch assembly.
3) Choose a unique unit address and configure your transmitter board according
to the table below. For unit addresses higher than 12, see Appendix H.
4) Configure every remaining transmitter board for this specific XP4000
Series unit with the same address.
5) Set these transmitters by the applicable XP4000 Series unit. Locate all
transmitters that will be installed in your next XP4000 Series unit, and
repeat steps 2 - 5 until you have reached the last XP4000 Series unit in
your system.
Transmitter/
Receiver Board
Configuration
Unit (8 ------ 1) Unit (8 ------- 1)
Address Setting Address Setting
1 00000001 7 00000111
2 00000010 8 00001000
3 00000011 9 00001001
4 00000100 10 00001010
5 00000101 11 00001011
6 00000110 12 00001100