User guide

46
Displaying Local/Remote Chassis Configurations
Choosing Option 1 from the main menu will bring up the table shown below,
displaying your XP4000 system's current configuration information. You will
be prompted for a chassis number, or address, before the table is displayed.
Enter a remote chassis address or press enter at the prompt for the local unit.
Note that the slot without a push-button or LED is designated by “M” and the
primary peripheral workstation, or the LCI, channel is designated by “N”.
System Management Tools
Main Menu
1) Display chassis configuration
2) Display Flash ROM status
3) Download Serial Port to Flash ROM
4) Reboot computer
5) Search for connected chassis
6) Set Date and Time
7) Transfer security log
Enter your selection:
EPROM FLASH
Chan Card Type HW Rev FW Rev FW Rev Serial # Other Information
---- --------- ------ ------ ------ ----------- -----------------
3-A Empty
3-B XPAC B03 * D-00 -NA- 0123456789 PC + PS/2 mouse
3-C XPAC C00 * D-00 -NA- 0123456789 No cable attached
3-D Empty
3-E Empty
3-F Empty
3-G Empty
3-H Empty
3-I XPXT A00 * C-04 -NA- 0123456789
3-J XPXT A00 * C-04 -NA- 0123456789
3-K Empty
3-L Empty
3-M XPRB A00 * C-06 CMON 0123456789
3-N Empty
* - Indicates active device.
Channel position
Hardware revision
Standard firmware revision
Upgrade firmware revision
Module type
P1[N/C] P2 [ 4-F]
P1[N/C] P2 [ 5-F]
Using System
Management
Tools
Once you have cycled to the Administrator Control Menu with Alt-Tab,
choose the System Management Tools option. You may also use the keyboard
shortcut Alt-T from anywhere within the XPIQ module. The menu below will
appear on your monitor. An explanation of each option follows.