User guide
142
Key Sequence Action
<CM>KMnnn<Enter> Sets the highest unit address that the system will scan
through during a session. Substitute nnn with a value from
1 to 254. Required for expansion systems only.
<CM>KM0<Enter> Resets scanning to include channels in the local unit only.
<CM>TG<Enter> Enables the Broadcast Go command
<CM>TH<Enter> Enables the Broadcast Halt command
<CM>T+
[channel list]
<Enter> Enables the Broadcast Add Channel (+) command
<CM>T-
[channel list]
<Enter> Enables the Broadcast Remove Channel (-) command
<CM>FOLLOW
Addr
<Enter> Sets the address of the leader console to be followed
<CM>FOLLOW+<Enter> Enables Follow Mode
<CM>FOLLOW-<Enter> Disables Follow Mode
<CM>SWAP
Addr
<Enter> Sets the address of the console to be swapped with
<CM>SWAP+<Enter> Enables Swap Mode
<CM>SWAP-<Enter> Disables Swap Mode
<CM>X
Addr
<Enter> Places a computer channel in Privacy Mode
<CM>SAVE<Enter> Saves user console configuration (i.e. Broadcast Mode,
DIP switch settings, KeyScan channels) settings to
permanent memory. Any configuration changes not saved
will not be retained after a power reset.
<CM>SW=
n
<Enter> Overrides DIP switch settings on XPAC/XPAB computer
interface modules. Sets the bank of switches (1-8) to a
user specified ON/OFF combination. To determine the
correct DIP switch code for your system (
n
), refer to
Appendix H.
<CM>SW+<Enter> Enables override of DIP switch settings.
<CM>SW-<Enter> Disables override of DIP switch settings.
<CM>CHASSIS=
n
<Enter> Changes the unit address of the local unit to
n
(0-254).
Used in expansion systems only. If your chassis does not
contain either an XPXT or an intelligent power supply
(XPPS-2), you will need to use this command to assign the
chassis a unit address. Valid chassis addresses are
necessary for proper upgrading of expansion systems.
<CM>SUN=
n
<Enter> Foreign Sun Workstations Only Sets all XPAC/XPAB
computer interface modules attached to Suns to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix G.
<CM>SUNI=
n
<Enter> Foreign Sun Workstations Only Sets the current XPAC/
XPAB computer interface module (Sun only) to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix G.