User guide

132
The following three pages contain configuration charts for the components of
your XP4000 Series system. Fill out Chart I for each channel containing a
computer interface module and Chart II for each channel containing a user
interface module. If you are using an expanded system you will either need to
fill out Chart III if you are using multiple XP4040 or 4080 units or Chart IV if
you are using XP4040 and 4080 units with XP4400 units.
Computer interface modules have a 44-pin male connector that fits through the
rear of the unit; user interface modules have a larger 62-pin female connector.
Channels are designated by letters on the front panel of the unit, with slot A to
the far right (viewed from the rear). See the diagrams below.
1xP REAR PANEL
XP4040 REAR PANEL
(Front Access Model)
XP4040 REAR PANEL
(Rear Access Model)
AC INPUT
90-240 VAC, 47- 63 Hz
1 AMP FAST BLOW
250 VAC
CHANNEL A
USER INTERFACE (XPLU)
CHANNEL M
LCI
CHANNEL A
USER INTERFACE (XPLU)
CHANNEL M
LCI
CPU INTERFACE (XPAC)
CPU INTERFACE (XPAC)
AC INPUT
90-240 VAC, 47- 63 Hz
1 AMP FAST BLOW
250 VAC
CHANNEL A
CPU INTERFACE (XPAC)
USER INTERFACE (XPLU)
CHANNEL N
CHANNEL A
USER INTERFACE (XPLU)
CPU INTERFACE (XPAC)
CHANNEL N