User guide

109
Displaying Local/Remote Chassis Configurations
Choosing Option 1 from the main menu will bring up the table shown below,
displaying your XP4000 system's current configuration information. You will
be prompted for a chassis number, or address, before the table is displayed.
Enter a remote chassis address or press enter at the prompt for the local unit.
Note that the slot with no push-button or LED is designated by “M” and the
primary peripheral workstation, or the LCI, channel is designated by “N”.
Displaying Local/Remote Flash ROM Status
XPRB modules contain seven storage, or Flash, positions that will hold
information for any Flash upgradable module in the system. You can download
the firmware for the XPLU, XPAB, XPRB, LCI, XPXT and XPXR modules
into these flash positions, and upgrade these modules through the XPRB
menuing system.
Choosing Option 2 from the main menu will bring up the table shown below.
You will be prompted for a channel address before the table is displayed. Enter
a remote channel address or press enter at the prompt for the local channel.
This table displays for you which module's firmware is in each location, and
the current revision level.
Flash
Pos Flash Type FW Rev
--- ----------- -----
1 XPRB CMON 1 of 1
2 XPLU C-02 1 of 1
3 XPXR C-04 1 of 1
4 XPXT C-04 1 of 1
5 Available
6 Available
7 Available
EPROM FLASH
Chan Card Type HW Rev FW Rev FW Rev Serial # Other Information
---- --------- ------------- ------ ------ ----------- -----------------
0-A XPAB
0-B Empty
A01
* D-00
-NA- ..........
PC + PS/2 mouse
0-C XPLU C00 C-02 -NA- ..........
P1 [ N/C], P2 [ 7-C]
0-D Empty
0-E Empty
0-F XPRB
0-G Empty
0-H Empty
0-I Empty
B02
* C-06
* XF82 0123456789
0-J XPXR C01 * C-04 * XF82 0123456789
0-K Empty
0-L Empty
0-M Empty
C00
* C-00 -NA- 0123456789
0-N LCI
* - Indicates active device.
Channel position
Hardware revision
Standard firmware revision
Upgrade firmware revision
Module type